BX Installation Help

Large b5e5ed49

BX Timber Holder Installation Instruction

 

-Take holder and twist whilst pushing down firmly onto re-bar until in position.

 -The Holder should be set at no more than 1000mm centres, repeat above step. 

 -Place timber into the holders and push firmly into position. 

 -The timber should be minimum of 45 x 90 the Holder will also take 100mm timber as well (4”x2”) (timber not supplied).

-Secure timber into place using the screw holes provided. It is recommended that 25mm tec screws be used. As Shown. (tec screws are not supplied).

 -Always refer to your site HSE requirements.

***Refer to the disclaimer tab

If any further information is required, please email or phone us via the contacts page.